- After pressing the Button for about 1 second, the LED briefly flashes green once and then turns off: The Board is currently powered on.
- After pressing the Button for about 3 seconds, the LED slowly flashes green twice and then turns off: The Board’s power has turned on from the off state.
- After pressing the Button for about 3 seconds, the LED briefly flashes green twice and then turns off: The Board has powered off.
- After pressing the Button for about 3 seconds, the LED flashes blue and then turns off: Entered setup mode.
- The LED is flashing red: The access token has not been automatically updated.
- In this case, please reconfigure the wireless LAN of the Catlog Board.
- For details on how to change/reconfigure the wireless LAN, see Catlog Board Troubleshooting.
Please note that the LED lighting patterns may vary depending on the firmware version of the Catlog Board. The above are based on the latest version announced in the Catlog app.
Note:
If Catlog Board is operating normally or running out of battery, the LED will be off.